back

Current software version ZE-NC2040

The rapid development of consumer electronics and computer equipment requires permanent adaption to stay up-to-date. In order to do so we have prepared a software-update for your E>GO device. Please check your present software version, following the procedure mentioned below, to determine if you need to update.

Main unit

V11.0 - (Setup > General > 2nd Page > Version):

• APP_V 2.89.26_03X1_101217
• MPG_V 2.4.18_0XXX_101217
• MCU_V 2.10.23_03X1_110607

Bluetooth Version (Bluetooth Mode > Setup > Version):

• SW330

Updating the software version

If the version number of your presently installed software is older, follow these links describing the required update process step-by-step:

• ZE-NC2040 Main unit and Bluetooth software update

Navigation Softwareupdates

Updates for the sat nav section of your naviceiver device can be accessed and downloaded over the Naviextras portal. For Naviextras to recognize your device, you need a USB stick with the software for file synchronization (“Synctool”) installed, as well as a dedicated map data manager software for browsing the update catalogue (“Toolbox”). Both required software bundles are available for download free of charge under the following links and together with the easy-to-understand PDF instruction sheets, you should have your sat nav content manager solution up and running in just a couple of minutes.

The following software gives full compatibility between your Zenec device and Naviextras Toolbox. For a smooth installation, please check the instructions:

Link to Synctool Download

ZENEC_EGO_Synctool_Instructions_UK.pdf Operating instructions for Navi-SyncTool

2.3 M

This Naviextras Toolbox is necessary to guaranty the compatibility between Naviextras and your navigation software. Please follow this guidance step by step to download the Toolbox.

Toolbox instructions

Toolbox download

back