The Device request a PIN for pairing in the Bluetooth- Modus, what shall I enter?
AW: You will find this information also in your manual – please enter four times zero (0000). At Z-E6150 this can also be changed in Bluetooth settings.
I don’t use the optional navigation card at Z-E6150, do I need to connect the GPS antenna?
AW: Yes, we suggest to connect it because the device does also sync date and time via GPS signal.
I have an active FM antenna in the vehicle. Do I need a FM- phantom adapter?
AW: AW: The scope of delivery includes an FM antenna adapter for Toyota vehicles. You just need to plug it in between the antenna and the device and then connect …
Can I use the factory installed BT hands free system of my car?
AW: No, this is not possible. All Zenec devices already include a hands free module. To avoid interference issues it is strongly suggested to deactivate your car’s built-in OE hands …
I would like to connect an external Bluetooth microphone at the Z-E6150, but the set does not contain such an microphone?
AW: Yes, the device has an internal microphone located on the front panel. An external microphone can be connected to the Z-E6150. There is a mic input on the device …
It is possible to use the original steering wheel remote control of my vehicle?
AW: Yes, normally the signals from the steering wheel remote control will be transmitted resistance-based. In addition to the main connection cable, you will find two additional, almost identical white …
During ignition of the engine my Zenec device powers off and reboot again.
AW: Zenec units include a low-voltage protection to avoid undersupply for certain integrated circuits (ICs) that may not work properly without correct and steady supply voltage. Please consult your car …