No GPS signal or frequent nav-voice prompts for re-calculated route.
AW: There are several reasons which could be root cause for such problems. Please check the place and position of your GPS-receiver which is usually behind the windscreen on the …
Can I edit contact favorites of the imported telephone book?
AW: It is not possible to edit favourites. But you can delete and re-assign a new contact after you updated the phonebook on your Zenec device by re-downloading it.
Changes in contacts of my smartphone are not adopted automatically?
AW: Your smartphone contacts will only be downloaded again when you confirm this action. Any later changes made to your contacts must be refreshed manually (see main device manual).
The device requests a PIN for Bluetooth pairing. What shall I enter?
AW: You will find this information also in your manual – please enter four times zero (0000). The Z-E1010 CORE SERIES allows to change this PIN number in its Bluetooth …
Can I use the factory installed BT hands free system of my car?
AW: No, this is not possible. All Zenec devices already include a hands free module. To avoid interference issues it is strongly suggested to deactivate your car’s built-in OE hands …
I would like to connect an external Bluetooth microphone on my Z-E1010 device. But the set does not contain an external microphone?
AW: It is possible to use an external microphone for improved hands-free audio performance. The external microphone can be connected on the backside of the Z-E1010 CORE device, since it …
When I start the engine my Zenec device powers off and reboot again.
AW: Zenec units include a low-voltage protection to avoid under supply for certain integrated circuits (ICs) that may not work properly without correct and steady supply voltage. Please consult your …