ZENEC E>GO device cannot be run / turned on when ignition of vehicle is off.
Answer: No, you cannot turn on the ZENEC E>GO device when ignition of vehicle is off. E>GO units are connected to the CAN network of the vehicle they are mounted …
Do the park sensors still work after mounting the ZE-NC5011D?
Answer: Yes, the park sensors and their audible messages still work.
Does the ZE-NC5011D support the ex-factory information displays?
Answer: Yes it does support the following displays: GID; CID; TID; BID.
Does the ZE-NC5011D offer steering wheel and driver information display integration?
Answer: Please make sure that the brown connector on the backside of the ZE-NC5011D is properly inserted. This wire lead transmits the CAN data between the interface to the ZE-NC5011D. …
How do i adjust Settings of the OE board computer?
Answer: Please make sure that the brown connector on the backside of the ZE-NC5011D is properly inserted. This wire lead transmits the CAN data between the interface to the ZE-NC5011D. …
What conditions must be met, to install the ZE-NC5011D unit?
Answer: The vehicle must be equipped with the „OE radio prearrangement“ from the factory, to allow straightforward installation of the ZE-NC5011D. The physical appearance of the OE installed radio must …
What do I need to consider for audio playback from USB source?
Answer: Make sure your USB data carrier has been formatted in FAT32 – prior to use. Zenec recommends the use of high quality USB sticks only. Study the corresponding key …